Tilted relative to contact point
With this option, SolidCAM enables you to define the tool tilting relative to the contact point.
Angles
The Lag angle to cutting direction parameter enables you to define the tool tilting in the direction of the cutting pass. The Lag angle to cutting direction parameter is measured relative to surface normal. |
 |
The Tilt angle at side of cutting parameter enables you to define the tool inclination in the direction determined by Side tilting options. The Tilt angle at side of cutting parameter is measured relative to surface normal. |
 |
|
When this option is chosen, the Tool contact point section in the Advanced tab is not available. |
