iMachining – Cutting technology detection

In the example below, the Floor option is enabled in the iRough + iFinish operation and then carried over to the following two iFinish operations.

	iRough + iFinish using a Ø12 mm (0.5 in) end mill
	Finish after finish using a Ø6 mm (0.25 in) end mill
	Finish after finish using a Ø3 mm (0.125 in) end mill

In the example below, the Floor option is enabled in the second operation and then carried over to the last operation.

	iRough + iFinish using a Ø12 mm (0.5 in) end mill
	Finish after finish using a Ø6 mm (0.25 in) end mill
	Finish after finish using a Ø3 mm (0.125 in) end mill

In the finish after finish operations of both examples, Step down is reduced to 1 for clarity.