Choosing the tool for the Center-Chamfer Drilling Operation

SolidCAM searches for the tool in compliance with the pre-defined tool type and angle. The search is performed in the Part Tool Library in the diameter range from the value of sum of hole diameter and Constant endlessly. The Constant is equal to 1. The tool with the maximum diameter will be chosen. If the tool with such diameter is not found, SolidCAM chooses the tool of any diameter with a pre-defined tool type and angle.  

In the case of the absence of a suitable tool, an error message is displayed and the tool for the operation will have to be defined manually.

 

   

 

 

Related Topics

  1. Choosing the tool
  2. Choosing the tool for the Center Drill Operation
  3. Choosing the tool for the Chamfer Drill Operation
  4. Choosing the tool for the Drill Operation
  5. Choosing the tool for the Mill Operation
  6. Choosing the tool for the Reaming Operation
  7. Choosing the tool for the Thread Operation