Sim. 5-Axis Geometry
The Geometry page enables you to define the geometry for the Sim. 5-Axis operation.
All machining technologies of the Sim. 5-Axis operation use a Drive surface geometry. Also, for each technology, additional geometries must be defined.
Morph between two boundary curves
Morph between two adjacent surfaces
Parallel cuts
This technology includes the following set of geometries:
Parallel to Curve
This technology includes the following set of geometries:
Parallel to Surface
This technology includes the following set of geometries:
Perpendicular to Curve
This technology includes the following set of geometries:
Morph between two boundary curves
This technology includes the following set of geometries:
Morph between two adjacent surfaces
This technology includes the following set of geometries:
Projection
Depending on the choosen strategy, this technology can include different sets of geometries: