Center drill tool
When this tool is used in combination with the Depth type option, SolidCAM calculates the drilling depth according to the following expression:
Drilling Depth = Tip Length + Arbor Diameter/2 + cotan(Shoulder Angle/2)
Parameter limitations
Parameter |
Range |
Tip Diameter |
Tip Diameter < Arbor Diameter |
Tip Angle |
0° < Tip Angle < 180° |
Shoulder Angle |
0° < Shoulder Angle < 180° |
Tip Length |
Tip Length <= Cutting Length |
Cutting Length |
Cutting Length <= Outside Holder Length |
Outside Holder Length |
Outside Holder Length <= Total Length |
The length of the conical part defined by Tip Diameter and Tip Angle must be equal to or smaller than the Tip length value. The length of conical part can be calculated according to the following expression: Cone Length = Tip diameter/(2*tan( Tip angle/2)).