Conversion to Chamfer Machinable Hole Feature segment

According to the General conversion rules explained earlier, the scheme of input data for the conversion will be the following.

The major parameters of the converted Chamfer Machinable Hole Feature segment will be the same as in the original Hole Feature segment:

• The Upper diameter (hr_segm_diameter) of the Chamfer segment will be equal to the Upper diameter of the initial Hole Feature segment.

• The Lower diameter (hr_segm_lower_diameter) of the Chamfer segment will be equal to the Lower diameter of the initial Hole Feature segment.

• The Height (hr_segm_height) of the Chamfer segment will be equal to the Height of the initial Hole Feature segment.

• The converted Chamfer segment is situated at the same depth as the original Hole Feature segment.

• The Chamfer Angle (hr_segm_angle) will be calculated automatically.