A |
The width of the
tool holder. |
B |
The distance between
the tool tip point and the side of the tool holder. Note that
a negative value will cause the holder side to move outwards from
the tool tip point. |
C |
The height of the
tool tip carrier. |
D |
The height of the
tool (not including the turret); must be greater than C. |
D1,
D2 |
The lengths of
the two cutting edges of the tool tip. These lengths define the
maximum step down size during turning. |
a° |
The tool tip angle; must be between 0 and
180 degrees. |
b° |
The angle between
the tool tip edge and a perpendicular passing through the tool
tip point. The sum of a°
and b° must be
smaller than 90. |
E |
The position of
the left side of the turret with reference to the tool tip point.
A negative value means that the left side of the turret will be
to the left of the tool tip point. |
F |
The width of the
turret. |
Ra |
The tool nose
radius. |
Thickness |
The thickness
of the tool. |